Low viscosity / light Aromatic process oil product Is fully rich aromatic RPO By-Product from Solvent Extracting Process to Modify Physical Properties of the Vulcanization and to reduce the Cost of the Finished Product. This Product Has Good Elastomeric Compatibility And Low Volatility. Light Aromatic Process Oil Well-Known According To Its Viscosity Which Meet ASTM standards and ISO 3104 (American Society For Testing And Materials) Standard Test Method For Kinematic Viscosity Of Transparent And Opaque Liquids (Calculation Of Dynamic Viscosity) . Low Aromatic Furfural extracts
Low aromatic extract oil component In Rubber Formulations And Manufacturing Of Products Such As :
LOW VISCOSITY RUBBER PROCESS OIL is stable in ambient conditions, non-corrosive and it can be stored in mild steel containers.The product is practically non-irritating to skin and eyes.Lubricants should be in a clean, dry storage. Storage temperature should be appropriate in all cases. All packing should keep away from all kinds of environmental pollutants such as dust and moisture .Lubricants based on their additive has different storage time , LOW VISCOSITY RUBBER PROCESS OIL has a long shelf time among other lubricants .Temperature fluctuations cause air movement between the environment and the top containers. if a barrel has any hole lubricant that does not have the temperature drop, in cold weather air goes into the drum and when weather is hot air go out of the drum . With air moisture particles go into containers and is likely to break the base material. Heat or too much cold can cause chemical analysis of lubricants. As previously mentioned, stainless steel may be degrading the quality only after six months of storage. Depending on the formulation, a stainless can have poor solubility in base oils and precipitate. This sedimentation during storage at low temperatures to raise a lot. Oil lubricants eager to absorb moisture in the air naturally . Humidity immediately begins to decompose oil additive and lubricant oxidation of the base material after entering the accelerating consumption cycle.
Packing LOW VISCOSITY RUBBER PROCESS OIL can be in new steel drum , one new steel drum capacity is 200-210 liter , recondition or used drum also can contain same quantity per drum totally 16.500 to 17.000 MT LOW VISCOSITY RUBBER PROCESS OIL can load on one 20foot container equal to 80 drum , ISO tank capacity is 20 MT net weight same as flexi tanks . Some customers who need to discharge the LOW VISCOSITY RUBBER PROCESS OILin their pool or tank use iso tank since they can warm up the LOW VISCOSITY RUBBER PROCESS OIL then it can discharge more easy therefore they would not have labor cost which is high in western and Oceania continent .