MES(MILD EXTRACTED SOLVATE)

DESCRIPTION OF MES :

MES are used to improve the process ability of rubber compounds or to increase the bulk of rubber in order to lower cost. They can can be broadly classified into three basic groups namely, paraffinic, naphthenic and aromatics. They are used in a large variety of finished products in the chemical and manufacturing industries.
We supply a wide range of high quality MES as we recognize the crucial role that MES plays in your products and operations.
This environment friendly process oil is typically used as plasticiser, extender and general processing aid for natural and synthetic rubbers and other polymers. It also has enhanced solvency properties in comparison with the other paraffinic process oils with similar viscosity.

APPLICATIONS OF MES:

Tyre Manufacturing
Tyre Retreading
Belt Manufacturing and Belting
Moulding
Extruding tubing and hoses
Fertilizers

STORAGE AND HANDLING OF MES

MES is stable in ambient conditions, non-corrosive and it can be stored in mild steel containers.The product is practically non-irritating to skin and eyes.Lubricants should be in a clean, dry storage. Storage temperature should be appropriate in all cases. All packing should keep away from all kinds of environmental pollutants such as dust and moisture .Lubricants based on their additive has different storage time , MES has a long shelf time among other lubricants .Temperature fluctuations cause air movement between the environment and the top containers.  if a barrel has any hole lubricant that does not have the temperature drop, in cold weather air goes into the drum and when weather is hot air go out of the drum . With air moisture particles go into containers and is likely to break the base material. Heat or too much cold can cause chemical analysis of lubricants. As previously mentioned, stainless steel may be degrading the quality only after six months of storage. Depending on the formulation, a stainless can have poor solubility in base oils and precipitate. This sedimentation during storage at low temperatures to raise a lot. Oil lubricants eager to absorb moisture in the air naturally . Humidity immediately begins to decompose oil additive and lubricant oxidation of the base material after entering the accelerating consumption cycle.

 

PACKING MES

Packing MES can be in new steel drum , one new steel drum capacity is 200-210 liter  , recondition or used drum also can contain same quantity per drum totally 16.500 to 17.000 MT MES  can load on one 20foot container equal to 80 drum  , ISO tank capacity is 20 MT net weight same as  flexi tanks  . Some customers who need to discharge the MES in their pool or tank use iso tank since they can warm up the MES then it can discharge more easy therefore they would not have labor cost which is high in western and Oceania continent .